Webcon Carburetor Products
Webcon High-Pressure Fuel Pressure Gauge 0 - 120 PSI / 0 - 8 Bar.
Ideal for setting the pressure on fuel injection systems.
Glycerin-filled for accurate reading under all circumstances.
Can be used with our Fuel Pressure Gauge Adapter.
Thread: 1/8th" tapered NPTF.
Note:This gauge should only be used for setting-up and then be removed for normal running.
Please use our superior quality PTFE tape each time that you (re-)assemble screwed connections in the fuel tract in order to properly seal the connection.As an alternative, you can use our Loctite 243 Thread Locker which will offer the added properties of protecting your connections from undoing themselves.
Webcon High-Pressure Fuel Pressure Gauge 0 - 120 PSI / 0 - 8 Bar
Webcon electric fuel pump cut-off safety switch.
This inertia switch detects the rapid change in velocity of a vehicle when impacted in any direction and is designed to be wired into the supply of the fuel pump to cut the power to the pump in the event of an accident.
The switch is normally immune to normal road vibration and road irregularities.
Suitable for under-bonnet fitment providing the switch is free from the risk of spillage of liquids or direct water spray.
The installation manual (in English) can be downloaded HERE.
Please note that this is the inertia switch ONLY. In order to wire this switch into you vehicle, you need a connector set which can be purchased separately or ordered right along with the switch by selecting it through the drop box at the top of this description.
Inertia Fuel Cut-Off Switch
Connector set for our Webcon Inertia Fuel Cut-Off Switch.
This set is required when you wire our Inertia Switch into your vehicle for the first time.
The installation manual (in English) for the Inertia Switch can be downloaded HERE.
Connector Set for Inertia Fuel Cut-Off Switch
Great looking "Bowler Hat" style airfilter with chromed mesh and baseplate to fit the Weber DMTL carburetors.
Made by Webcon.
The total package contains the following:
The total height is circa 60 mm.
Please note that the base plate will need slight alteration to make it fit onto a Land Rover with 32/34 Weber DMTL.
Bowler Hat Airfilter for Weber DMTL carburetors
Great looking "Bowler Hat" style airfilter with chromed mesh and baseplate to fit the Weber DMTR carburetors.
Bowler Hat Airfilter for Weber DMTR carburetors
Great looking "Bowler Hat" style airfilter with chromed mesh and baseplate to fit the Weber DFTH carburetors.
Bowler Hat Airfilter for Weber DFTH carburetors
Dellorto, Weber and Solex Carburettors Spare Parts Jets Chokes Emulsion Tubes Service Kits